When tin-bearing sand middlings are continuously recirculated on a shaking table, common issues include an ever-increasing recirculation volume, unstable feed delivery to the deck, and simultaneous fluctuations in concentrate grade and tailings losses. Simply adding more shaking table units merely expands the recirculation volume. Middlings are a mixed product that cannot yet be classified as either concentrate or tailings; it is essential to determine whether they consist of coarse-grained composite particles, liberated cassiterite particles that were misdirected during separation, or low-value material entrained by slimes.

Only by separately measuring the middlings-and simultaneously recording the dry mass and grade of the raw ore, concentrate, tailings, and middlings over the course of a full shift-can one determine whether the circulating load is genuinely increasing. Relying solely on feed pump flow rates can be misleading due to variations in slurry concentration. If the middlings volume is high but the grade is close to that of the tailings, the cut width may be excessive; if the middlings grade is high and fluctuates significantly, one should inspect particle size, wash water conditions, and deck.
The results of size-fraction analysis determine the processing strategy: middlings should be separated into size fractions achievable in the plant for assaying and to observe the degree of cassiterite liberation. Coarse middlings consisting primarily of composite particles can be sent for light-load regrinding; middlings within the size range suitable for shaking tables that already contain liberated cassiterite should be returned to the corresponding size fraction for re-treatment; and fine middlings showing significant tin enrichment require treatment via fine-slime shaking tables, centrifugal equipment, or separate hydraulic classification.
The middlings should be returned directly to the appropriate processing stage. The earlier the return point in the circuit, the more equipment is involved in the cycle, making the circulating load harder to control. Classified middlings must not be remixed with unclassified raw ore, nor should they be returned to a different size fraction. A safer approach is to return the middlings-sorted by size-to the corresponding shaking table feed box, utilizing independent metering and pulp conditioning to prevent the middlings' concentration from adversely affecting the main feed.
If regrinding is applied to the entire middlings fraction-which includes coarse composite particles-there is a risk of over-grinding already liberated cassiterite into fine slime. Before regrinding, the coarse fraction should be screened out and verified-via microscopic examination or comparative testing-to ensure the particles remain intergrown with minerals such as quartz and sulfides. The regrinding circuit should operate under a light load in a closed-loop configuration to minimize the generation of new fine slime; the reground product should then be re-classified prior to gravity separation.
Operational issues on the shaking table-such as fluctuations in middlings reduction concentration, excessive wash water, improper transverse slope, or overly wide splitter settings-can cause material that should have reported to the concentrate or tailings to be diverted into the middlings stream. When making adjustments, alter only one key parameter at a time and verify results using product samples collected during the same period. The goal is to ensure the boundaries between concentrate, middlings, and tailings remain stable and interpretable. Once the three product streams are established and equipment capacity is expanded to handle size-specific balances, the middlings should be routed along three distinct paths: "return of same-size material," "re-grinding of coarse composite particles," and "separate recovery of fine liberated particles." Only if the tonnage in any of these paths consistently exceeds capacity should the addition of more shaking tables or centrifugal concentrators be considered. Eliminating ineffective circulation loops before expanding capacity generally leads to more stable recovery of alluvial tin.







